At the Exploratory Studies Facility at Yucca Mountain, workers have excavated a series of four test alcoves on the right side of the tunnel. Here, scientists have tested how air, water, and other gases move through layers of rock within Yucca Mountain.

The tests conducted within these alcoves helped researchers understand how water or gases behave in the natural environment within Yucca Mountain. For example, one of the components of spent nuclear fuel is radioactive carbon dioxide (14CO2). Scientists needed to understand how this gas and other fluids travel naturally through the layers of thick volcanic rock at Yucca Mountain.


Determining important geologic features

During excavation of the alcoves, scientists carefully mapped fractures, joints, and other geologic features. Using special cameras, technicians recorded detailed, three-dimensional pictures of each alcove. Scientists used these to find the best places within the alcove to conduct specific tests.


Measurements of permeability were the primary testing conducted in each alcove. Permeability is a measure of the degree that gas (categorized as a fluid or liquid) can move through rock. It depends on the size and extent of fractures within the rock, the amount and size of pore space between the grains or crystals of the rock, and the connectivity of the fracture system.

These studies produced a detailed picture of how gases and liquids can move through the mountain.


How do scientists measure fluid moving through rock?

Scientists are interested in where gases and liquids flow and at what rate of speed. Generally, fluids travel through dense rock exceptionally slowly, a few inches over hundreds, and even thousands, of years. But where fractures exist, fluids may move much more quickly.

Of interest then are:

• How do liquids and gases get from one point to another?
• How do they move through fractures?
• Do they move at different rates through rock layers?
• What happens at the intersections of such layers?

By injecting a constant flow of pressurized air into specific areas, scientists were able to gain answers to these questions.

To reach this goal, workers dry-drilled a total of seven boreholes within the alcoves and removed the rock core produced. They had to be especially careful when choosing where to drill their boreholes to insure realistic results.

Specially designed plugs were placed inside each borehole at different levels so that segments were kept isolated for testing. These plugs not only kept the segments isolated, but also helped monitor the direction of the flow of gas within the borehole.

Tracer gas was injected into one borehole. The presence of gas—when detected by special instruments and sensors within the other two boreholes—yielded important information about the mountain’s permeability.

Other tests were also conducted in each alcove. Scientists collected rock samples to study their mineral content, and to learn more about their origin and composition. Rocks can reveal much about the geologic past. For example, a careful analysis will show how old a sample is, what pressures and temperatures shaped it, and even establish what the material was like that formed the rock.

Finally, scientists looked for layers and traces of calcite-silica deposits in the alcoves and in their analyses of rock samples. This provided information about how old the deposits are and how they were deposited by water moving through the layers of rock.


U.S. Department of Energy
Office of Civilian Radioactive Waste Management

Yucca Mountain Project

1551 Hillshire Drive
Las Vegas, NV 89134
1-800-225-6972
http://www.ocrwm.doe.gov

DOE/YMP-0006
November 2004